Atop-technology EH7510 User manual Instrukcja Użytkownika Strona 104

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 120
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 103
Atop Industrial Managed Ethernet Switch
EH7510
User Manual V 1.0
98
Fig. 3.4
3.4.1 Administration Setup using Serial Console
This section shows how users can see administration information and make changes using
command. Detailed explanations of each technical term can be found in Chapter 2 of this
manual.
Table 3.2
Command
Description
sntp <IP-add> <before-utc | after-utc>
<0 ~ 24 hours>
Starts SNTP service.
[no] dhcp
Enable or disable DHCP.
show dhcp
Shows DHCP status.
ip address<ip-addr> <ip-mask>
Set IP address and subnet mask.
Ip default-gateway <ip-addr>
Set the gateway IP address
show ip
Show IP address, subnet mask, and the default
gateway.
Boot
Use this command to reboot the switch.
Show running-config
Display the running configurations of the switch.
copy running-config startup-config
Backup the switch configurations.
erase startup-config
Reset to default factory settings at next boot time.
Show arp
Show the IP ARP translation table.
Ping ip-addr <1~999>
Send ICMP Echo-Request to network host.
<1 ~ 999> specifies the number of repetitions.
Exec
Switch to shell mode. Shell mode may do shell
command.
Przeglądanie stron 103
1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 119 120

Komentarze do niniejszej Instrukcji

Brak uwag